Heater Installation Process: Step By Step Guide

Posted on

In countries that experience cold winter months, having a central heating system is not uncommon. Nothing beats staying warm through the coldest of nights. The problem comes with installing the system because most people are confused about where the various parts should go. Luckily for you, this article breaks down the installation process giving you a step-by-step guide.

Step 1: Select the Right Equipment

When it comes to a central heating system, you need three primary components–a radiator, control system, and gas boiler. You should pay keen attention, especially when choosing a gas boiler. Its size determines your system's heating capability. You might want to go for a gas boiler that is big enough to heat your house but also not so big as to escalate gas bills. As to the radiator, go for one that complements your interior décor as it is easily noticeable.

Step 2: Install Radiators

Do not place your radiator directly on the ground. Instead, leave a 4- to 6-inch allowance to house heating valves. Typically, two valves are installed below the radiator. One of them is a lockshield, while the other is a wheel valve. The valves serve to improve water flow circulation in the radiator.

Step 3: Attach Pipes From the Radiator Leading to the Boiler and Faucets

A boiler sends heat to the radiator through pipes housed beneath the floor. Plastic or copper pipes are usually chosen for this purpose. For them to allow heat flow, they have to reach the boiler. You should check to ensure the pipes are fully functional.

Step 4: Install the Control System

Commonly known as the thermostat, the control system comes next. It should be remembered that there is a wide range of control systems, and each of them requires different installation techniques.

The control system is at the center of the central heating installation. This part is responsible for sending signals to the rest of the components to start warming.

Step 5: Install the Boiler

Now that the control system is in place, it is time to install the boiler. While at it, make sure you disconnect the gas and water supply. Boilers also come in different forms, and each has different installation techniques. If you find it hard to follow the manual, you can call in a professional. You may want to choose a boiler with air conditioning options.

Step 6: Activate the Heat Pump

To finish up, get the heat pump going. To do this, you need to close the radiator vents to allow water circulation. The circulation continues until it finally balances out within the system. This is where the lockshield valves come in. The valves allow water to move through without dripping.

If you are having trouble installing your central heating system, the above comprehensive guide might be just what you have been missing. Try DIYing or engage a professional like those at Dr HVAC, Inc.


Share